CBN Stropping Paste PDTOOLS 3/2 40g
Code: PD CBNP3/2Related products
Product detailed description
CBN Compound is the very effective method of honing and polishing the cutting edge of the knife. CBN (Cubic Boron Nitride) is the second hardest material after diamond.
CBN's qualities include its high levels of high hardness, strength, abrasion resistance, and thermal and chemical resistance. These characteristics exceed the values of synthetic diamonds and conventional abrasives such as silicon carbide and aluminum oxide. In particular, CBN's high thermal stability and chemical resistance make it suitable for sharpening in conditions where synthetic diamonds are not normally employed.
CBN Compound can be used with any strop made of smooth or coarse leather, balsa or felt. Smooth leather is best strop material for CBN compound.
CBN Compound does not require any preparations. However, you can experience difficulty to take the compound from the container if your air temperature is below 20°C (68°F). In such case, you can slightly warm compound to make it molten. Take a small amount of compound and evenly distribute it to a surface of the strop.
You will not be able to fully remove the compound after applying it to the strop. If you want to use your strop both with and without compound, you must, therefore, keep one side clean. If you want to switch between one compound and another, consider buying an extra strop.
Compound residue accumulates in the leather during stropping. If stropping performance gets worse, remove the residue with a knife spine or special tool, and apply the fresh compound.
Features
- grain size: (3/2 µm) 5000 grit
- Dimensions of one: 4.5 cm (base) x 6.5 cm (height)
- Total weight: 52 g
- Paste weight: 40 g
Additional parameters
| Category: | NEWS |
|---|---|
| Zrnitosť: | 5000 grit |
| Materiál: | CBN |
| Hmotnosť pasty: | 40 g |
The history of the enterprise dates back to 1966 when it was established as “Poltava Plant of Synthetic Diamonds and Diamond Tools” following the country’s directive to develop and master the technology of diamond synthesis and diamond tool production.
In 1966, diamond powder was synthesized for the first time at the plant. Within a short period, the plant became the largest producer of grinding and micro-powders of synthetic diamonds in the USSR.
Today, PJSC “Poltava Diamond Tools” is a modern enterprise specializing in the production of a wide range of diamond and CBN tools for the manufacturing and sharpening of tools made of hard alloys and high-speed steels; grinding and polishing of parts made of hard alloys, heat-resistant, alloyed, and stainless steels, glass, ceramics, silicon, refractory materials, precious stones, and other materials; cutting of products made of hard alloy, glass, marble, granite, quartz, ceramics, and construction materials; drilling of glass and highly reinforced concrete, and more.